ADVANCED Motion Controls introduces most configurable analog servo drives to date

Available immediately are the B060A400AC and B100A400AC analog brushless servo drives providing up to 21kW and 35kW respectively.

Greenville, DE- Available immediately are the B060A400AC and B100A400AC analog brushless servo drives providing up to 21kW and 35kW respectively.

The B060A400AC is capable of outputting 60A peak and 30A continuous while the B100A400AC outputs 100A peak and 50A continuous. These servo drives can operate with both AC and DC supply voltages with an AC voltage range of 200-240VAC and a DC voltage range of 255-373 VDC. The built-in shunt circuit alleviates regeneration issues to increase the maximum deceleration rate of large inertial loads. Modes of operation include: Current, Duty Cycle, Voltage, IR Comp, Encoder Velocity, Hall Velocity and Tachometer.

DIP Switch selectable settings allow fine-tuning to match motor and machine dynamics without having to change components on the board. Included are 17 current loop integrator gain settings, 32 current loop proportional gain settings, 8 velocity loop integrator gain settings and 4 tachometer scaling settings. In addition, selectable inhibit logic, fault logic and linear ramping make these drives compatible with more controllers. With so many configuration options these are our most configurable analog servo drives ever.

These new servo drives are suited for a wide range of applications including: assembly/general factory automation, satellite ground station positioning, robotics, testers, metalworking machines, alternative energy control, simulators and more.

More information on the B060A400AC and B100A400AC from Advanced Motion Controls can be found at the link below-

For more information, please contact:

Warren Osak
Toll Free Phone: 877-378-0240
Toll Free Fax: 877-378-0249

Tags: AMC, Advanced Motion Controls, Servo Amplifier, Brushless Amplifier, PWM Amplifier, Servo2Go, BLDC Amplifier, Servo Drive, Servo Drive Amplifier

Featured Product

SCHUNK's New Safety Gripping System EGN

SCHUNK's New Safety Gripping System EGN

With the SLS, SOS, and STO functionalities, the SCHUNK EGN gripping system certified in accordance with DIN EN ISO 13849 enables safe human/machine collaboration. If the production process is interrupted by an emergency shut-off, the SCHUNK EGN goes into either a safely limited speed mode or a safe stop mode depending on the activated protection zone. In contrast to other solutions available on the market, the SCHUNK safety gripping system is continuously powered even in the safe operating stop so that the gripped parts are reliably held even without mechanical maintenance of gripping force. As soon as the protection zone is released, the gripper immediately switches back to the regular operating mode without the system having to be restarted.