TORC Robotics to Tackle High-Speed Autonomous Vehicle Navigation Challenges

Cross-Platform Software and Sensor Payload to Enable Autonomous Vehicle Operations up to 100 KPH

BLACKSBURG, VA (January 17, 2012) - TORC Robotics has been subcontracted through the Robotics Technology Consortium (RTC) to develop an advanced sensor fusion system for the Department of Defense that will significantly increase high-speed obstacle detection range. This long-range obstacle detection, classification and prediction system will enhance autonomous navigation capabilities for unmanned ground vehicles operating in mission-relevant environments at speeds up to 100 KPH. The system will be capable of detecting and maintaining a variety of tracking statistics for each obstacle. TORC will incorporate these enhanced capabilities with its core autonomy framework for future availability in its AutonoNav™ product line.


To support integration with the project sponsor's autonomy framework, TORC will develop an Application Programming Interface (API) for the advanced sensor fusion software, and build a hardware prototype capable of installation on a range of vehicles including the HMMWV and LMTV. The system fuses asynchronous and heterogeneous sensor modalities through a joint probabilistic data association approach to reduce false positive/negative data, which is essential to high-speed autonomous navigation. TORC will achieve long-range detection and classification through a combination of commercial-off-the-shelf LIDAR, radar and vision technologies from Ibeo, Velodyne, and Smartmicro. TORC will assess sensor and fusion performance at high-speed under a variety of man-made weather conditions to include rain, dense fog and snow at the Virginia Tech Transportation Institute (VTTI) Smart Road.

"Despite recent deployments of full-sized autonomous vehicles for operational assessments in Afghanistan, most are still quite limited in their ability to operate autonomously and at high speed outside of their pre-planned scenarios," states Andrew Culhane, Business Development Manager at TORC. "The reality is that military UGVs need to be able to operate autonomously within complex mission environments while keeping pace with the force. In order for that to happen, UGV perception technology must be capable of detecting, classifying and predicting obstacles at longer ranges while moving at operational speeds."

TORC will leverage software initially conceptualized under a DARPA SBIR now under further research on the RTC Sensor-based Collision Prediction project. This project provides the software architecture and obstacle prediction capabilities that TORC will extend to meet the requirements for this project. The primary research platform for this project is the ByWire XGV™, a drive-by-wire controlled ground robotics vehicle.

TORC will demonstrate the new long-range obstacle detection, classification and prediction capabilities in 2012. Results of this work should open up new possibilities for deploying autonomous vehicles for missions that demand navigating at higher speeds in unstructured environments. For more information, visit TORC Robotics online or contact Andrew Culhane at 1-540-443-9262.

ABOUT TORC

TORC enables engineers to rapidly integrate robotic systems through a suite of modular, customizable products. Leading academic, commercial and government organizations use the TORC's Robotic Building Blocks™ product line to shorten the development process, lower costs and mitigate risks. These products have been used on more than 100 mobile robots ranging from 15 pounds to 15 tons. TORC provides solutions for drive-by-wire conversion, emergency stop, power management, autonomous navigation and operator control. For more information, visit http://www.torcrobotics.com.

TORC, TORC Robotics, Robotic Building Blocks, AutonoNav and ByWire XGV are trademarks of TORC.

Featured Product

Piab’s Kenos KCS Gripper

Piab's Kenos KCS Gripper

Piab's Kenos KCS gripper enables a collaborative robot to handle just about anything at any time. Combining Piab's proprietary air-driven COAX vacuum technology with an easily replaceable technical foam that molds itself around any surface or shape, the gripper can be used to safely grip, lift and handle any object. Standard interface (ISO) adapters enable the whole unit to be attached to any cobot type on the market with a body made in a lightweight 3D printed material. Approved by Universal Robots as a UR+ end effector.