CURSIR solution was selected by NPO RTS as a tool for pre-flight checks at the commissioning of navigational aids

NPO RTS has completed the installation of the ILS 734 instrument landing system at Magas Airport in the Republic of Ingushetia. One of the innovations that made it possible to significantly reduce the duration of the landing system preparation for the control flight inspection was the use of the NAVAID calibration drone developed by CURSIR.

CURSIR solution was selected by NPO RTS as a tool for pre-flight checks at the commissioning of navigational aids.


NPO RTS has completed the installation of the ILS 734 instrument landing system at Magas Airport in the Republic of Ingushetia. One of the innovations that made it possible to significantly reduce the duration of the landing system preparation for the control flight inspection was the use of the NAVAID calibration drone developed by CURSIR.

"The NAVAID calibration drone designed by CURSIR makes it possible to conduct a preliminary inspection and setup of equipment. It significantly accelerates commissioning and minimizes the raid of a specialized flight inspection aircraft when checking the navigation aids," - CEO V. Munirov said. "For our company, the use of this advanced technology has become a mandatory practice, ensuring superiority over competitors in the speed and accuracy of the equipment commissioning."

NAVAID calibration drone is a tool designed by CURSIR for the inspections of navigational aids and airport infrastructure. The solution consists of a drone, a payload (an analyzer or a camera), a ground base station, and software.

CURSIR - a manufacturer and service provider - was founded in Russia in 2015 to carry out scientific and practical research for landing and navigation systems and systems for their diagnostics and control.

Featured Product

ATI Industrial Automation - MC-50 Manual Tool Changer

ATI Industrial Automation - MC-50 Manual Tool Changer

With intuitive and ergonomic lever operation, the patent-pending MC-50 Manual Robot Tool Changer provides a simple solution for quickly changing robotic end-of-arm tooling by hand. This compact and robust Tool Changer is designed for applications on collaborative robots that support payloads up to 25 kg and small industrial robots supporting payloads up to 10 kg. Featuring an ISO 50 mm mounting interface on the Master-side and Tool-side, the low-profile MC-50 mounts directly to most cobots and seamlessly integrates with many common cobot marketplace grippers and end-effectors.