XBee Customizable Handheld Controller

Quantum Robotics is looking for funding on Kickstarter for two XBee based controller. They already reached their goal of $7,000 but you can still contribute and get a first run controller.

Q4 Controller

  • 32 Channels
  • 4 Gimbals Joysticks (Horizontal, Vertical, & Push-button control)
  • 4 (10K Ohm Linear) Potentiometer Dial Controls
  • 10 Push-buttons
  • 6 Toggle Switch Controls
  • 1 Power On/Off Toggle
  • Micro SD Card Slot
  • 2x20 Serial LCD
  • Power requirements: 6-9 VDC (2S 500mAh Lipo or 9V battery

Q2 Controller

  • 24 Channels
  • 2 RC Gimbals (Horizontal & Vertical control)
  • 4 (10K Ohm Linear) Potentiometer Dial Controls
  • 10 Push-buttons
  • 6 Toggle Switch Controls
  • 1 Power On/Off Toggle
  • Micro SD Card Slot
  • 2x20 Serial LCD
  • Power requirements: 6-9 VDC (2S 500mAh Lipo or 9V battery)

 

Comments (0)

This post does not have any comments. Be the first to leave a comment below.


Post A Comment

You must be logged in before you can post a comment. Login now.

Featured Product

REIKU's Cable Saver™ - The Most Versatile Modular Robotic Cable Management Solution

REIKU's Cable Saver™ - The Most Versatile Modular Robotic Cable Management Solution

REIKU's Cable Saver™ Solution eliminates downtime, loss of revenue, expensive cable and hose replacement costs, maintenance labour costs. It's available in three sizes 36, 52 and 70 mm. All of the robots cables and hoses are protected when routed through the Cable Saver™ corrugated tubing. The Cable Saver™ uses a spring retraction system housed inside the Energy Tube™ to keep this service loop out of harms way in safe location at the rear of the Robot when not required. The Cable Saver™ is a COMPLETE solution for any make or model of robot. It installs quickly-on either side of the robot and has been tested to resist over 15 million repetitive cycles.