Advanced Motion Controls Release µZ Servo Drives
µZs are the smallest off-the-shelf servo drives from ADVANCED Motion Controls
Camarillo, CA- Weighing only 8.5 grams and capable of outputting 10A peak and 5A continuous µZs are the smallest off-the-shelf servo drives from ADVANCED Motion Controls. Pronounced 'Micro-Z these plug-in drives are designed for embedded applications in a wide range of industries including: Robotics, Lab Automation, Homeland Security/Military, Electric Mobility, Medical and Packaging.
These full featured drives operate with brushless and brushed servo motors and are available for immediate shipment.
µZ Servo Drives are Current Mode drives that measure 1.5" on a side and output 10A peak and 5A continuous at up to 36VDC.
Designed without the need for a heatsink, the µZs are true featherweights with a high power to weight ratio. The µZs are fully protected against over-voltage, under-voltage, over-current, over-heating, and short-circuits.
Depending on the model, the drives interface with digital controllers that have analog ±10 V or PWM/Direction commands. These servo drives require only a single unregulated isolated DC power supply, and are fully RoHS (Reduction of Hazardous Substances) compliant.
Click on the link below for more information on the new servo amplifiers from AMC-
https://www.servo2go.com/search.php?search=10A4&D=PROD
Featured Product
US Digital's New L2 Low Profile Motor Encoder
The L2 incremental encoder uses US Digital's proven EM1 optical encoder module and disk, which has billions of device-hours of dependable service in customer applications. This product continues US Digital's strong reputation for reliable, field-tested encoders. The L2 is US Digital's lowest height encoder that uses the EM1 module. It has a 0.75 in. bolt-spacing mount. The maximum resolution is 1250 CPR (5000 PPR with quadrature). The L2 comes with a single-ended output. Another benefit of the L2 incremental encoder is its fast installation. The cover snaps onto the base to secure the module. It is designed for use with a high-retention connector or cable (sold separately). Like all US Digital products, the L2 is designed and manufactured in Vancouver, Washington, USA. It is backed by prompt access to our technical and customer service teams with same-day shipping on most orders.
